The Temperature control installation kit has all the parts you will need to install a hand shower with warm water. You will connect two self cutting taps one on the hot water pipe and one on the cold water pipe. The thermostatic mixing valve once adjusted will automatically adjust the temperature for you so no need to manually worry about the water being to hot or too cold. By following the instruction guide written by our installation team, you will be able to install the hand shower within 20-40 minutes with basic DIY knowledge.

Included in the temperature installation kit is :

Thermostatic mixing valve	£50.00	2 x Self cutting taps	£10.00
2 x connection hoses	£8.00	2x 1/2'' adaptor	£7.00
Tape & washers	FREE	Instruction guide	FREE

Before ordering please check that you can access both hot and cold pipes,you can find them behind the sink going to the cold and hot water tap. only a small section is need about 20cm so it is ok if your pipes are partially covered. Please do not hesitate to contact us by telephone or email for any further information.

We do offer an temperature control installation service which comes with a six months guarantee for only £40 or alternatively you can hire a plumber to install the hand shower for you.

Some homes have a very high water pressure, which can damage the hand shower. It is recommend to order a pressure reducer valve which will fix this problem.

Please note: Simple Hygiene can not be held responsible for any damage or injury caused in the installation and use of any products supplied.